Buttons and Jumpers
The reset button has the following functions:
Hold this button during boot time until LED light starts flashing, release the button to reset RouterOS
configuration (total 5 seconds).
Keep holding for 5 more seconds, LED turns solid, release now to turn on CAP mode. The device will
now look for a CAPsMAN server (total 10 seconds).
Or Keep holding the button for 5 more seconds until LED turns off, then release it to make the
RouterBOARD look for Netinstall servers (total 15 seconds).
Regardless of the above option used, the system will load the backup RouterBOOT loader if the button
is pressed before power is applied to the device. Useful for RouterBOOT debugging and recovery.
Accessories
The package includes the following accessories that come with the device:
⎓Switching Power Supply DC 24 V;
Hose Clamp, 35-70 mm;
Fastening set K-41;
Gigabit POE injector cable with shielded connector;
Mounting bracket.
Please visit wiki pages for the MikroTik SFP module compatibility
table: https://wiki.mikrotik.com/wiki/MikroTik_SFP_module_compatibility_table
Operating system support
The device supports RouterOS software version 6.46. The specific factory-installed version number is
indicated in the RouterOS menu /system resource. Other operating systems have not been tested.
To avoid pollution of the environment, please separate the device from household waste and dispose of
it in a safe manner, such as in designated waste disposal sites. Familiarize yourself with the procedures
for the proper transportation of the equipment to the designated disposal sites in your area.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
