1.
2.
3.
NetBox 5
RB911G-5HPacD-NB
Quickstart
Please follow these quick steps to set up your device:
Remove the upper cover (see " ").NetBox 5#Removing upper cover
Connect an external antenna to the SMA connector (see " ").NetBox 5#Antenna usage
Open the bottom cover (see " ").NetBox 5#Opening bottom cover
Connect the device to the power source (see " ").NetBox 5#Powering
Open network connections on your PC, mobile phone or other device and search for MikroTik wireless network and connect to it.
Recommended using the WinBox configuration tool .https://mt.lv/winbox
Default IP for the device is 192.168.88.1, user name: a and there is no password.
dmin
Depending on the antenna used, you must set its gain in the RouterOS software to ensure that EIRP meets the limit set by the local authorities.
This is done in the Wireless menu.
Click the "Check for updates" button and update your RouterOS software to the latest version to ensure the best performance and stability.
Choose your country, to apply country regulation settings and set up your password in the screen that loads.
Powering
The device accepts power in the following ways:
Ethernet port accepts Passive PoE 8-30 V DC .
The power consumption under maximum load can reach 11.5 W.
Connecting to a PoE Adapter:
Connect the Ethernet cable from the device to the PoE+DATA port of the PoE adapter.
Connect an Ethernet cable from your local network (LAN) to the PoE adapter.
Connect the power cord to the adapter, and then plug the power cord into a power outlet.
Removing upper cover
This device needs to be upgraded to RouterOS v6.46 or the latest version to ensure compliance with local authority regulations.
It is the end users responsibility to follow local country regulations, including operation within legal frequency channels, output
power, cabling requirements, and Dynamic Frequency Selection (DFS) requirements. All MikroTik radio devices must be
professionally installed.
To Next Page
Need help?
General
Weight and Dimensions
