Milesight Ultra Series - Serial Port

71
6.4.1 Serial Port
This section explains how to configure serial port parameters to achieve communication with serial
terminals, and configure work mode to achieve communication with the remote data centers, so as to
achieve two-way communication between serial terminals and remote data centers.
Serial Setting
Item
Description
Default
Enable
Enable or disable serial port function.
Disable
Serial Type
Serial Port 1 is a RS232 port and Serial Port 2 is a RS485 port.
--
Baud Rate
The range is 300-230400. Same with the baud rate of the
connected terminal device.
9600
Data Bits
8 bits or 7 bits optional. Same with the data bits of the connected
terminal device.
8
Stop Bits
1 bit or 2 bits optional. Same with the stop bits of the connected
terminal device.
1
Parity
Options are None, Odd and Even. Same with the parity of the
connected terminal device.
None
Software Flow
Control
Enable or disable software flow control.
Disable
Serial Mode
Select work mode of the serial port.
DTU Mode: In DTU mode, the serial port can establish
communication with the remote server/client.
GPS: In GPS mode, go to Industrial > GPS > GPS Serial Forwarding
to configure basic parameters to send GPS data to serial port.
Disable