MILESTONE
USER MANUAL
Ethos EZ User manual MA073-006 Installation chapter - 12 -
ETHOS EZ SETUP
Lift-up the main carton box to facilitate the removal of the ETHOS EZ.
The ETHOS EZ comes protected by a plastic bag to avoid it getting wet during
transportation.
Provide a bench of at least 1m length and 80cm wide and locate the ETHOS EZ on the
bench.
The unit requires sufficient clearance (approx. 15 cm) on all sides to allow adequate
movement of air.
A proper location of the ETHOS EZ is next to a fume hood, since the microwave unit should
be connected to the fume hood by using the hose supplied (details will follow).
WARNING
The weight of the ETHOS EZ is approximately 75 kg. At least 3 people should
remove the system from its box by lifting under the four corners of the unit and
place it on the bench.
Place the unit on a lab bench:
To Next Page
Loading...
