8 millnorway.com
EN
Before use:
Be aware that the Mill app must be installed before you can connect your heaters to
your WiFi network. You can then simply follow the instructions given in the app when
connecting your heaters. The heaters will connect directly to your router via WiFi with 2,4
Ghz mode b/g/n. Bluetooth is needed for provisioning, so make sure its enabled.
Minimum OS requirement: iOS 8.0 and Android 5.0.
Go to our help desk at millnorway.com for more information or if you have any questions
regarding the Mill app, connecting to WiFi or other relating questions.
ATTENTION! The heaters will be connected directly to your WiFi router and it is
therefore important to make sure the router has sufficient capacity for the number
of active devices connected at the same time.
Color codes (WiFi control light)
The heater has not been connected to WiFi. The heater keeps an even temperature
throughout the whole day and night.
The heater is online in the Mill cloud.
When installing/connecting the Mill-app and cloud, the light will flash in various speed.
This is normal.
The heater has a problem connecting to or finding the WiFi si gnal.
Please do the following:
1. Please turn the heater OFF and ON again.
2. Please restart the WiFi router.
3. Please check the WiFi router to make sure the capacity is sufficient for the num-
ber of active devices connected at the same time.
4. Please make sure 2,4 Ghz is activated. If the problem persists, please get in touch
with support.
The heaters are offline and have no contact with the Mill cloud.
Activating WiFi
See figure 7 on separate illustration sheet
Press «add heater» on the home screen in the Mill-app. Follow the instructions in the app.
Delete WiFi setting
See figure 8 on separate illustration sheet
For CO1200WIFI3 and CO1200WIFI3BLACK: Press and hold WiFi button for 5 seconds.
For CO1500MAXWIFI3: Press and hold until you see Sr in the display.
Maintenance
1. For cleaning, always unplug the heater and leave it to cool.
2. Wipe the heater regularly with a damp cloth and dry the surface before turning on the
heater again.
To Next Page