MILL CO1200WIFI3 - Assembly; Temperature Calibration; Memory Function; Resetting the Heater

5
EN
Assembly
See figure 3 on separate illustration sheet
1. Remove the pre-mounted screws on both legs before you Insert the legs into the
brackets, so that you get a stable foot.
2. Attach the legs to the brackets by tightening 2 screws into each bracket.
3. Remove the pre-mounted screws from the bottom of the heater and place the heater
gently on its head to mount the feet.
4. Two screws must be fastened on each foot bracket.
5. NEVER USE THE HEATER BEFORE THE LEGS HAVE BEEN TIGHTLY SCREWED.
Temperature calibration
See figure 4 on separate illustration sheet
It may occur deviation between the temperature registered by the heater and the actual
temperature in the room. This can be caused by several reasons, however, the most
common is that the heater is placed in a fair distance from where you usually reside. When
you set the temperature to for example 22 degrees, it is only natural that you expect the
same temperature where your sofa is placed for instance. However, the temperature
sensor is placed on the product itself, and therefore a deviation in temperature may occur.
To adjust this, all Mill heaters are equipped with a calibration function, which enables you
to adjust the temperature registered by the heater. N.B! The room must have achieved a
stable temperature before any calibration.
For CO1200WIFI3 and CO1200WIFI3BLACK: Press ○2 times and use + or - to set
the actual temperature observed in the room. Confirm with○or wait 15 seconds for
automatic confirmation.
For CO1500MAXWIFI3: Press and hold until you see CAL in the display. Use + or
- to set the actual temperature in the room. Confirm with or wait 15 seconds for
automatic confirmation.
Memory function
If the heater is connected to WiFi it will automatically reconnect with WiFi (where all
temperatures are saved) after a power cut.
Resetting the heater
See figure 5 on separate illustration sheet
Turn off the heater's main switch. Turn the heater back on, within 5 seconds press and
hold ○. After 20 seconds the display will show "Fr", once you see "Fr" release ○and
the heater will reset to factory settings.