6 millnorway.com
EN
the temperature registered by the heater. N.B! The room must have achieved a stable
temperature before any calibration.
Press
○ 2 times and use + or - to set the actual temperature observed in the room. Con-
○
Resetting the heater
Turn off the heater's main switch. Press and hold
○ while you turn on the heater's main
switch.
Memory function
The heater remembers all the temperature settings and will automatically return to the
desired temperature after a power cut. Your day- and nighttime setbacks will however be
deleted after a power cut, and you will need to register the programs again.
"Open window" function
The heater has an "open window" function that is activated instantly when it registers a
sudden drop in temperature with more than 2 degrees Celsius in 2 minutes. The heater will
automatically stop heating and FO will be visible in the display of the heater.
The heater will automatically start heating again after 10 minutes (the display switch from
FO to desired room temperature).
Instructions electronic thermostat
Control panel
1. Display (shows the desired room temperature by default)
2. Power indicator - shows whether the heater is using power or not
3. Control button ( +) (increase temperature)
5. Function button
ATTENTION! After a power cut the thermostat will return to the last registered temperature
WARNING! BEFORE THE HEATER IS TURNED ON, IT MUST BE ATTACHED TO A
WALL. IF THE HEATER IS NOT INSTALLED CORRECTLY OR IS INSTALLED ASKEW,
THIS MAY CAUSE THE HEATER TO MALFUNCTION OR IN THE WORST CASE, BE
DAMAGED.
If the temperature sensor is not functioning properly, you will see this symbol
on the display. Please contact the dealer or importer.
To Next Page
Loading...
