MILL Invisible Series - Instructions day;night thermostat; Control panel; Power indicator for day;night thermostat

7
EN
Power indicator for electronic thermostat
 
When the panel heater is using power (i.e. when it is heating), the power indicator is lit
.
Set desired temperature for electronic thermostat
 
Press the arrow buttons to set the desired temperature.
Instructions day/night thermostat

TIP! The thermostat can be used as a regular electronic thermostat (i.e. the heater will

tronic thermostat for further information.
Control panel
 
1. Display (shows the desired room temperature by default)
2. Control light - night function
3. Control light - day function

5. Control button ( +) (Increase temperature)

7. Night function
8. Day function
9. Function button
Power indicator for day/night thermostat
 
When the panel heater is using power (i.e. when it is heating), the power indicator is lit
.
ATTENTION! After a power cut the thermostat will return to the last registered temperature
WARNING! BEFORE THE HEATER IS TURNED ON, IT MUST BE ATTACHED TO A
WALL. IF THE HEATER IS NOT INSTALLED CORRECTLY OR IS INSTALLED ASKEW,
THIS MAY CAUSE THE HEATER TO MALFUNCTION OR IN THE WORST CASE, BE
DAMAGED.
If the temperature sensor is not functioning properly, you will see this symbol
on the display. Please contact the dealer or importer.