EN-13
2. Remove the 4 original screws (❶) Of the opening at the rear of the monitor. Follow the
instructions received with your mount, cradle or accessory and install the monitor on the wall or
fixing your choice. Remember to use the screws included 2 fixing elements at the rear of the
monitor. See the picture (❷) For the correct placement of the screws.
original screw x 4
Use 2 screws 2
35 mm
2
Use 2 screws 2 17 mm
- Use only the screws No. 2 (35 mm x 2, 17 x 2 mm) provided with this type of
installation.
- Do not discard the original screws because they may be needed for later use.
3. Follow the instructions received with your mount, cradle or accessory and install the monitor on the
wall or fixing your choice.
Mounting Bracket
(Not included)
To Next Page
Loading...
