Millenium MD49 - PIP (Picture in Picture); PBP (Picture by Picture)

EN-22
Jitter / Moiré
• Electrical equipment located nearby may interfere with the monitor.
The light is on or flashing, but no image is displayed on the screen
• Check whether the monitor is on.
•
Check that the graphics card is installed correctly.
•
Make sure the power cable is properly connected to the monitor and the power source.
The image position is not centered / size is not correct
• Please adjust settings Clock or Automatic.
Difference colors (the colors are not optimized)
• Adjust RGB color settings or reset the color temperature.
12.2 - Information on the entry PIP (Picture in Picture)
Fashion
Input source
from
the
Home screen
Additional source of input
Picture in Picture
Exchange
Window
Picture Mode
DP
HDMI
mode 1
DP
X
O
O
O
mode 2
HDMI
O
X
O
O
Note: "O" means that this function is supported while "X" means that it is not supported.
12.3 - Information on the resolution PBP (Picture by
Picture)
When using this function and to obtain an optimal viewing experience, it is recommended to set the
two panels at the same resolution.
A
t this resolution, image and visual distortion tear must be reduced.
It is recommended to set the
second panel with resolution
1440p at 60Hz.
2
It is recommended to set the
resolution.
1