With this function, you can turn the built-in tone generator on or off. If you only want to use
the MIDI data sent by the device, you should disable the internal tone generator in order to
reduce latency.
1.
Press the button [SETUP ] and use [PAGE] to select the parameter Local.
2. To disable the function, turn the rotary control [–] / [+] to the left until ‘OFF’ is displayed.
To enable the function, turn the rotary control [–] / [+] to the right until ‘ON’ is displayed.
3.
Use [PAGE] to select the next parameter or quit the Setup menu with [EXIT].
ð
Then the confirmation prompt appears on the display: ‘Save Setups’. ‘Yes’. For
storing, press [ENTER] or turn the rotary control to the left so that ‘No’ is flashing and
then press [ENTER]. Then you quit the menu without storing.
You can use the drume module to adjust the Touch sensitivity of each pad.
1. Press [SETUP].
2.
Use [PAGE] to select the menu item ‘Advance’.
3. Press [ENTER] to open the Advance menu.
ð
The parameter Sensitivity for TOM1 is displayed as the first setting value.
Local
Touch sensitivity
Operating
e-drum module
36
To Next Page
Loading...
