The drum module allows you to adjust the dynamic range of the individual pads and thus, the
signal-to-noise ratio.
1. Press [SETUP].
2.
Use [PAGE] to select the menu item ‘Advance’.
3. Press [ENTER] to open the Advance menu.
ð
Use [PAGE] to switch to the setting parameter Headroom.
4. Activate the desired pad using the pad select buttons or by striking it.
ð
The name of the selected pad appears in the display.
5. Adjust the dynamic range of the pads using the rotary control [–] / [+] to the desired
value (range from 0 to 127).
6.
Activate the next pad or use [PAGE] to select another desired setting parameter.
Here you can enter the timespan for the unit to ignore a second triggering. This can suppress
double-triggers caused by vibration.
1. Press [SETUP].
2.
Use [PAGE] to select the menu item ‘Advance’.
Dynamic range
Sense-Time
Operating
MPS-500 USB
39
To Next Page
Loading...
