1. Press [SETUP].
2.
Use [PAGE] to select the menu item ‘Advance’.
3. Press [ENTER] to open the Advance menu.
ð
Use [PAGE] to switch to setting parameter Note Send.
4. Activate the desired pad using the pad select buttons or by striking it.
ð
The name of the selected pad appears in the display.
5. Use the rotary control [–] / [+] to set the desired note value (range 0 to 127).
6.
Activate the next pad or use [PAGE] to select another desired setting parameter.
Press [EXIT] to change upwards from the Advance menu to the Setup menu. Press
again [EXIT] to close the Setup menu. The display shows ‘Save Setups’. Button right,
‘Yes’ is flashing. If you now press [ENTER] the changes are stored and the Setup menu
will be closed. If you turn the rotary control [–] / [+] to the left, ‘No’ is flashing. If you
now press [ENTER] the changes will not be stored when closing the Setup menu.
Operating
e-drum module
42
To Next Page
Loading...
