Need help?Do you have a question about the Milnor 42044 CP2 and is the answer not in the manual?
Explains how to understand key identifying information on the cover of the manual.
Clarifies that troubleshooting procedures are now integrated, not on separate yellow pages.
Lists the various trademarks owned by Pellerin Milnor Corporation used in their products.
Provides contact information for submitting comments and suggestions for manual improvement.
Details specific lubrication points, types of grease, and frequency for machine components.
Instructions for lubricating the main bearings and seals, emphasizing proper technique.
Guidance on checking and maintaining the oil level in the gear reducer.
Specifies lubrication for jackshaft bearings and hydrocushion suspension cylinders.
Describes the function and operation of the clutch, brake, and drive system.
Provides step-by-step instructions for removing and installing bearings and seals.
Focuses on the critical aspects of cleanliness and correct installation of bearings and seals.
Explains the precise method for adjusting bearing clearances for optimal performance.
Details the procedure for rebuilding an air cylinder using a repair kit.
Presents a parts list and diagram for the Burket steam valve assembly.
Covers general installation requirements and procedures for transferring the machine.
Guides the user on connecting water, steam, and air services to the machine.
Describes how to adjust rest pads for level machine resting during operation.
Provides a chart of recommended fuse and wire sizes based on machine model and voltage.
Explains the importance of lag-type fuses and wire sizing for motor starting current.
Provides detailed dimensional drawings for the 42044NP2/CP2 Washer Extractor.
Shows dimensional information for optional configurations of the 42044NP2/CP2.
Provides detailed dimensional drawings for the 42031NP2/CP2 Washer-Extractor.
Shows dimensional information for optional configurations of the 42031NP2/CP2.
To Next Page
General
