R
Pellerin Milnor CorporationPellerin Milnor Corporation
P. O. Box 400, Kenner, LA 70063-0400
Litho in U.S.A.
BMP700710/96081V
(Sheet 1 of 2)
Hays Electric Inlet Valves
BMP700710/96081V (1 of 2)
THOSE VALVES WITH COUPLING NUTS
MUSTY NOT BE EXCESSIVELY
TIGHTENED. USE A STEADY PULL WITH A
14" OR SMALLER WRENCH. DO NOT
HAMMER ON NUT OR WRENCH. LIMIT
MAXIMUM TORQUE ON COUPLING NUT
TO 600LB/INCH. EXCESSIVE
THIGHTENING OF COUPLING NUT WILL
DISTORT VALVE BODY CAUSING THE
PISTON BODY TO JAM AND THE VALVE
WILL NOT SHUT OFF.
IF THE VALVE LEAKS BETWEEN THE
BODY AND BONNET, LOOSEN THE
COUPLING NUT AND TURN THE BODY
SLIGHTLY, THEN TIGHTEN THE
COUPLING NUT. IF THE VALVE STILL
LEAKS, REPEAT THE OPERATION. IN NO
CASE MUST THE NUT BE TIGHTENED
EXCESSIVELY.
GENERAL MAINTENANCE:
1)
2)
*4108
SERIES
ONLY
HAYS 4108 SERIES DUOVALVE IS
REPLACED BY THE 3108 SERIES(SHOWN).
IF REPLACEMENT PARTS ARE NEEDED FOR
THE OBSOLETE 4108 SERIES SEE PARTS
LIST ON REVERSE SIDE.
NOTE:
00S,00W,00X,00XX
3/8" BALANCING & 3/4" VALVES
00T,00U,00V
1/2" DUO VALVES
00Y,00Z,00ZZ
1-1/4" VALVES
To Next Page
Loading...
Need help?
General
