Milnor Phase 7.2.2 - Page 30

28
2: PROGRAM “A-F” CYCLE
SELECT “A-F” KEY
* (“*” DISPLAY THE LETTER CHOSEN. DEFAULTS TO “A”)
SELECT CYCLE TYPE
* (“*” DISPLAY THE CYCLE TYPE “AUTO” or “MANUAL”)
AUTO
0: REVERSE MODE
ON
OFF
1: ENTER DRY TEMP 160° F TO 200° F (71° C TO 93° C)
*** F (“***” = THE DEFAULT DRY TEMP FOR THAT CYCLE)
2: ENTER DRYNESS LEVEL FINISH, DRY, EXTRA DRY
*** % (“***” = THE DEFAULT DRY LEVEL FOR THAT CYCLE)
3: ENTER CYCLE ADJUSTMENT LEVEL 0 TO 99
(75 = DEFAULT)
4: ENTER CONTROLLED COOL DOWN
(OFF = DEFAULT VALUE)
5: ENTER COOL DOWN TIME 0 TO 90 MINUTES
(4 = DEFAULT VALUE)
6: ENTER COOL DOWN TEMPERATURE 70° F TO 100° F (21° C TO 38° C)
(80 = DEFAULT VALUE)
MANUAL
0: REVERSE MODE
ON
OFF
1: ENTER SPIN TIME 30 TO 120-SECONDS
*** SEC (60 = THE DEFAULT TIME FOR THAT CYCLE)
ENTER STOP TIME 5 TO 10-SECONDS
*** SEC (5 = THE DEFAULT TIME FOR THAT CYCLE)
2: ENTER DRY TEMP 100° F TO 200° F (38° C TO 93° C)
*** F (“***” = THE DEFAULT DRY TEMP FOR THAT CYCLE)
ENTER CONTROLLED COOL DOWN ON OR OFF
(OFF = DEFAULT)
3: ENTER DRY TIME 0 TO 99 MINUTES
** MIN (0 = THE DEFAULT MINUTES FOR THAT CYCLE)
4: ENTER COOL DOWN TIME 0 TO 99 MINUTES
** MIN (4 = THE DEFAULT TIME FOR THAT CYCLE)
5: ENTER COOL DOWN TEMP 70° F TO 100° F (21° F TO 38° C)
*** F (100 = THE DEFAULT TEMP FOR THAT CYCLE)
6: ENTER STEAM INJECTION ON OR OFF
(OFF = DEFAULT VALUE)
3: PROGRAM “0-40” CYCLE
1: SEE 2: PROGRAM “A-F” CYCLE
4: DEFAULT SETTINGS
ENTER PASSWORD
(PRESS “1” “2” “3”)
CONFIRM DEFAULTS
NO (DEFAULT VALUE)
YES