To Next Page
G
gabrielle16Jul 25, 2025
What to do if the ACC on my Milton Roy MILROYAL D Water Pump always moves to the same position?
- MMatthew BrownJul 25, 2025
If the ACC moves to the same position regardless of the signal applied, the issue could be due to an improper command signal or an incorrect mode setup. First, connect a mA meter into the signal line to read the signal. If necessary, correct the signal source, as there may be a broken wire or loose connection. If the signal is correct, review the initial start-up procedure to ensure the mode setup is correct.
General
