Need help?Do you have a question about the Milwaukee M18 FUEL ONEPD2 and is the answer not in the manual?
General| Voltage | 18V |
|---|---|
| Battery Platform | M18 |
| Battery Type | Lithium-ion |
| Chuck Type | Keyless |
| Chuck Size | 1/2 inch |
| Max. drilling diameter in steel | 1/2 inch |
| Max. drilling diameter in masonry | 1/2 inch |
| Max Torque | 1, 200 in-lbs |
| Max. torque | 1, 200 in-lbs |
| No-Load Speed | 0-2, 000 RPM |
| No-load speed gear 1 | 0-550 RPM |
| No-load speed gear 2 | 0-2, 000 RPM |
| ONE-KEY enabled | Yes |
Keep work area clean, well lit, and free of flammable materials. Prevent unauthorized access.
Ensure proper grounding, avoid wet conditions, use suitable cords, and employ RCDs where necessary.
Remain alert, use common sense, wear appropriate PPE, and prevent accidental starting.
Use the correct tool, maintain it properly, and follow operating instructions for safe use.
Use specified chargers and battery packs, handle with care, and avoid extreme temperatures or damage.
Have tool serviced by qualified person using identical parts; never service damaged battery packs.
Wear ear protectors for impact drilling, use auxiliary handle, hold by insulated gripping surfaces.
Never operate at higher speed than bit rating, start drilling at low speed, apply pressure in line with bit.
Lists electrical and physical specifications of the tool, including voltage, battery type, RPM, BPM, and bit sizes.
Explains common symbols used in the manual, such as Volts, Direct Current, RPM, BPM, RCM, and read operator's manual.
Instructions for removing/inserting the battery pack and installing the side handle.
Steps for inserting and removing drill or screwdriver bits into the chuck.
Details on the ONE-KEY™ indicator lights and how to use the app for configuration.
How to set the torque selector collar for hammer drilling, drilling only, or driving screws.
Instructions on how to choose between low and high speed settings for the tool.
Guide for setting the forward, reverse, and lock positions of the control switch.
How to start, stop, and vary the speed of the tool using the trigger.
Techniques for drilling in various materials, including speed selection and bit types.
Guidance on drilling metal, including recommended bits, lubrication, and cooling.
Instructions for drilling masonry, including mode selection, bit types, and pressure.
Instructions for regular maintenance, inspection, and cleaning of tool contacts.
Procedure for replacing the internal battery used for ONE-KEY™ functionality.
Contact information for authorized dealers, service agents, and customer service.
To Next Page