USER MANUAL
MC110, MC120, MC122
PRO Digital pH Controller
& Monitors
milwaukeeinstruments.com (USA & CAN)
milwaukeeinst.com
SPECIFICATIONS
Range 0.0 to 14.0 pH
Resolution 0.1 pH
Accuracy
(@25°C)
±0.2 pH
Setpoint
3.5 to 7.5 pH for MC110
5.5 to 9.5 pH for MC120 and MC122
Alarm
active when measure is higher/lower
than selected setpoint depending on
user selection
Output Power
Socket
(for MC122 only)
active when measure is higher/lower
than selected setpoint (5A max)
depending on user selection
Power Drivers
(for MC122 only)
115VAC, 2A, 60Hz or 230VAC, 1A, 50Hz
pH Electrode MA911B/2 (included)
Environment 0 to 50°C, 95% RH not condensing
Power Supply 12 VDC (included)
Dimensions 148.5 x 82.5 x 32 mm
Weight
MC110, MC120 160 g (meter only)
MC122 180 g
OPTIONAL ACCESSORIES
M10004B pH 4.01 buer solution, 20 ml sachet (25pcs)
M10007B pH 7.01 buer solution, 20 ml sachet (25pcs)
M10010B
pH 10.01 buer solution, 20 ml sachet
(25pcs)
M10000B
Electrode rinse solution, 20 ml sachet
(25pcs)
MA9015
Electrode storage solution, 20 ml sachet
(25pcs)
CERTIFICATION
Milwaukee Instruments conform to the CE
European Directives.
Disposal of Electrical & Electronic
Equipment. Do not treat this product
as household waste. Hand it over to the
appropriate collection point for the recycling
of electrical and electronic equipment.
Please note: proper product prevents potential
negative consequences for human health and the
environment. For detailed information, contact your
local household waste disposal service or go to
www.milwaukeeinstruments.com (USA & CAN) or
www.milwaukeeinst.com.
RECOMMENDATION
Before using this product, make sure it is entirely
suitable for your specific application and for the
environment in which it is used. Any modification
introduced by the user to the supplied equipment
may compromise the meter’s performance. For your
and the meter’s safety do not use or store the meter in
hazardous environment. To avoid damage or burn, do
not perform any measurement in microwave ovens.
WARRANTY
These instruments are warranted against defects in
materials and manufacturing for a period of 2years
from the date of purchase. Probe is warranted for
6 months. This warranty is limited to repair or free
of charge replacement if the instrument cannot be
repaired. Damage due to accidents, misuse, tampering
or lack of prescribed maintenance is not covered by
warranty. If service is required, contact your local
Milwaukee Instruments Technical Service. If the repair
is not covered by the warranty, you will be notified of
the charges incurred. When shipping any meter, make
sure it is properly packaged for complete protection.
ISTMC110_07_20
SATISFACTION
GUARANTEED