Milwaukee MW102 User Manual

USER MANUAL
MW102
PRO pH/Temperature
Meter
milwaukeeinstruments.com (USA & CAN)
milwaukeeinst.com
OPTIONAL ACCESSORIES
MA9004 pH 4.01 buer solution, 230 mL bottle
MA9007 pH 7.01 buer solution, 230 mL bottle
MA9010 pH10.01 buer solution, 230 mL bottle
MA9015
Electrode storage solution,
230 mL bottle
MA9016
General cleaning solution,
230 mL bottle
M10000B Rinse solution, 20 mL sachet (25 pcs.)
SE-220
pH electrode with BNC connector and
1 m cable
MA830R Temperature probe
SPECIFICATIONS
RANGE
-2.00 to 16.00 pH
-5.0 to 105.0°C
RESOLUTION 0.01 pH / 0.1°C
ACCURACY (@25°C)
±0.02 pH / ±0.5°C
TYPICAL EMC DEV. ±0.02 pH / ±0.5°C
TEMPERATURE
COMPENSATION
Automatic,
-5.0 to 105.0°C
CALIBRATION Automatic, at 1 or 2 points
pH ELECTRODE SE-220 (included)
TEMPERATURE
PROBE
MA830R (included)
ENVIRONMENT 0 to 50°C; RH 95% max.
BATTERY TYPE 1 x 9V alkaline (included)
BATTERY LIFE approx. 750 hours of use
AUTO-OFF after 8 minutes of non-use
DIMENSIONS 143 x 80 x 32 mm
WEIGHT 220 g (with battery)
CERTIFICATION
Milwaukee Instruments conform to the
CEEuropean Directives.
Disposal of Electrical & Electronic
Equipment. Do not treat this product as
household waste. Hand it over to the
appropriate collection point for the recycling of
electrical and electronic equipment.
Disposal of waste batteries. This product
contains batteries. Do not dispose of them
with other household waste. Hand them
over to the appropriate collection point for recycling.
Please note: proper product and battery disposal
prevents potential negative consequences for human
health and the environment. For detailed information,
contact your local household waste disposal service
or go to www.milwaukeeinstruments.com (USA &
CAN) or www.milwaukeeinst.com.
RECOMMENDATION
Before using this product, make sure it is entirely
suitable for your specific application and for the
environment in which it is used. Any modification
introduced by the user to the supplied equipment
may compromise the meter’s performance. For your
and the meter’s safety do not use or store the meter in
hazardous environment. To avoid damage or burn, do
not perform any measurement in microwave ovens.
WARRANTY
This instrument is warranted against defects in
materials and manufacturing for a period of 2 years
from the date of purchase. Probe is warranted for
6 months. This warranty is limited to repair or free
of charge replacement if the instrument cannot be
repaired. Damage due to accidents, misuse, tampering
or lack of prescribed maintenance is not covered by
warranty. If service is required, contact your local
Milwaukee Instruments Technical Service. If the repair
is not covered by the warranty, you will be notified of the
charges incurred. When shipping any meter, make sure
it is properly packaged for complete protection.
Milwaukee Instruments reserves the right to make
improvements in design, construction and appearance
of its products without advance notice.
SATISFACTION
GUARANTEED
ISTMW102 07/20

Milwaukee MW102 Specifications

General

Category	pH Meter
Model	MW102
Dimensions	145 x 80 x 38 mm
Weight	220 g
Display	LCD
Range	0.0 to 14.0 pH
Environment	0 to 50°C (32 to 122°F)
Input Impedance	10¹² Ohm