11
MAINTENANCE
Maintaining Machine
To reduce the risk of injury,
always unplug the charger and
remove the battery pack from the charger or
machine before performing any maintenance.
Never disassemble the battery pack, charger, or
machine, except as provided in these
instructions. Contact a MILWAUKEE
®
service
facility for all other repairs.
Keep your machine, battery pack and charger in
good repair by adopting a regular maintenance
program. Inspect your machine for issues such as
undue noise, misalignment or binding of moving
parts, breakage of parts, or any other condition that
may affect the machine operation. Return the
machine, battery pack, and charger to a
MILWAUKEE
®
service facility for repair.
If the machine does not start or operate at full power
with a fully charged battery pack, clean the contacts
on the battery pack. If the machine still does not
work properly, return the machine, charger and
battery pack, to a MILWAUKEE
®
service facility for
repairs.
Grease Zerks
ONE-KEY™
WARNING
Chemical Burn Hazard.
This device contains a
lithium button/coin cell battery. A new
or used battery can cause severe in-
ternal burns and lead to death in as
little as 2 hours if swallowed or enters the body.
Always secure the battery cover. If it does not
close securely, stop using the device, remove the
batteries, and keep it away from children. If you
think batteries may have been swallowed or en-
tered the body, seek immediate medical attention.
securely.
Internal Coin Cell Battery
An internal coin cell battery is used to facilitate full
ONE-KEY™ functionality.
To replace the coin cell battery:
1. Remove the battery pack.
2. Remove the screw(s) and open the coin cell bat-
tery door.
3. Remove the old coin cell battery, keep it away from
children, and dispose of it properly.
4. Insert the new coin cell battery (3V CR2032), with
the positive side facing up.
5. Close the battery door and tighten the screw(s)
Cleaning
Cleaning the Battery and Battery Bay
Keep battery connections and surfaces between the
machine and battery free of debris and materials.
Failure to keep surfaces clean may result in mis-
alignment and/or damage to the battery connection.
Repairs
For repairs, return the machine to the nearest
authorised service centre.
WARNING
Use only recommended accesso-
ries. Others may be hazardous.
ACCESSORIES
For a complete listing of accessories, go online to
milwaukeetool.com.au / milwaukeetool.co.nz or
contact a distributor.
Use medium viscosity, synthetic, high temperature
grease. Apply five pumps of grease to the zerks
once a year.
Clean dust and debris from vents. Keep handles
clean, dry and free of oil or grease. Use only mild
soap and a damp cloth to clean, since certain
cleaning agents and solvents are harmful to plastics
and other insulated parts. Some of these include
petrol, turpentine, lacquer thinner, paint thinner,
chlorinated cleaning solvents, ammonia and
household detergents containing ammonia. Never
use flammable or combustible solvents around
tools.
To Next Page
Loading...