MIMAKI CJV30-100 - Page 313

© 2009 MIMAKI ENGINEERING CO.,LTD.
8.5.2 P.5
8.5.2 #TEST
1
2
3
4
5
6
7
8
#CUT PATTERN /SQUARE
COUNT = 1
[] / []
#CUT PATTERN
PATTERN :SQUARE
#CUT PATTERN /SQUARE
XY = 15mm COUNT= 1
#CUT PATTERN /SQUARE
DRAW START :ent
[] / []
#CUT PATTERN
PATTERN :10m
#CUT PATTERN / 10m
DRAW START :ent
[] / []
#CUT PATTERN
PATTERN :2m
#CUT PATTERN / 2m
DRAW START :ent
[] / []
#CUT PATTERN
PATTERN :QUALITY
#CUT PATTERN/QUALITY
DRAW START :ent
#CUT PATTERN
PATTERN :TEST
#CUT PATTERN / TEST
Number of Times= 1
#CUT PATTERN / TEST
DRAW START :ent
#TEST
CUT PATTERN <ent>
#OPTION OUTPUT
OUT1: OFF OUT2: OFF
#TEST
OPTION OUTPUT <ent>
[] / []
The number of times is not limited
when [Number of Times = 0].
Enters REMOTE mode and
performs drawing.
Enters REMOTE mode and
performs drawing.
Enters REMOTE mode and
performs drawing.
Enters REMOTE mode and
performs drawing.
R.1.0
Maintenance Manual > Operation Flow > Service Mode > #TEST
Model CJV30/TPC Issued 2008.08.04 Revised F/W ver. 1.00 Remark
1.0
Rev.