4-24
8
Press to select [FRAME CUT]
and press the key.
• When you want to cut a frame, select "ON".
9
Press to select [MARK CUT]
and press the key.
• When you want to attach marks for pasting, select "ON".
10
Press the key several times to return to LOCAL.
Cancelling the Setting of Dividing and Cutting
• The set values are recorded even when the power has been turned OFF.
• Because a mark for pasting is 1 cm long, the width of an effective cut area needs to be 1 cm or more.
• During the operation of dividing and cutting, data sent from the host computer is ignored.
• Dividing and Cutting cannot be performed in any of the following cases:
When the data size is larger than the reception buffer capacity
When an origin change command is contained in the cut data
When register mark detection is performed
When the width of an effective cut area is 1 cm or less
When the test data stored in this machine has been cut
Perform the operations in Steps 1 to
6 in "Setting the Dividing and
Cutting Function".
Press
to select "OFF".
Press .
Press key
several times.
To Next Page
Loading...
