MIMAKI CJV30-160 - Initializing the Settings

4-41
4
Extended Functions – Cutting –
Initializing the Settings
1
Press the key in LOCAL to select the
cutting mode.
2
Press the key.
3
Press the key.
4
Press to select one from the tool conditions (CUT1 to CUT3, PEN, and
HALF) and press the key.
5
Press to select [SETUP RESET].
6
Press the key.
7
Press the key.
• The set items and parameters are initialized.
8
Press the key several times to return to LOCAL.
• The set value is retained even when the power is turned "OFF".
<LOCAL . C >[#01]
CUT 1 ( 3 0 / 6 0 / 0 . 3 0 )
FUNCT I ON C
SETUP <ENT>
SETUP
SELECT : CUT1
[CUT1]
SETUP RESET <e n t >
[ CUT1 ] SETUP RESET
RESET : e n t