MIMAKI CJV30-60 - Replacing the Cutter Blade

6-41
6
Maintenance
Replacing the Cutter Blade
The medium cutter blade is consumable. When the cutter blade gets dull, replace it with a new one (SPA-0107).
1
Press the key in LOCAL to select cutting
mode.
2
Press the key.
3
Press to select [MAINTENANCE].
4
Press the key.
5
Press to select [TOOL REPLACE].
6
Press the key.
7
Press the key.
• The cutter unit moves to the left end of the machine.
• The blade is sharp. Be careful not to hurt yourself or anyone else.
• Store the cutter blade in a place that is out of the reach of children. In addition, dispose of used cutter
blades according to regional laws and regulations.
• When replacing the cutter blade, it is recommended to place a sheet of paper under the cutter blade.
This will help pick up the cutter blade if it drops.
<LOCAL . C > [ #01 ]
CUT 1 ( 3 0 / 6 0 / 0 . 3 0 )
FUNCT I ON C
SETUP <ENT>
FUNCT I ON C
MA I N T ENANCE < EN T >
MA I N T ENANCE
MARK S ENSOR < e n t >
MA I N T ENANCE
TOOL REPLACE < e n t >
TOOL REPLACE
ACT I ON :
e nt