3-13
Changing the Set Values of the Heaters
3
Extended Functions – Printer –
5
Press to select [HEATER].
6
Press the key twice.
• The heater temperature setting screen appears.
7
Press to set the temperature of each
heater.
Heater selection: Select one with .
Temperature setting: Set the temperature with .
8
Press the key.
9
Press to select [SET TIME].
10
Press the key.
11
Press to set time.
Item selection: Select one with .
Time setting: Set time with .
12
Press the key.
13
Press the key several times to end the setting.
• The screen returns to LOCAL.
• Use this machine at a temperature between 20 to 35°C. The temperature may not reach the set value,
depending on the ambient temperature conditions.
[1]
HEATER < e n t >
PRE PRT POST
2 5°C 2 5°C 3 5°C
PRE PRT POST
3 5°C 4 0°C 5 0°C
Set temperature: 20 to 50°C
[1]HEATER
SET TEMP . <e n t >
[1]HEATER
SET T I ME <en t >
STANDBY : OFF T I ME
1 0mi n : NONE
STANDBY : OFF T I ME
1 0mi n : NONE
Set value: NONE, 0 to 90 min
(by the unit of 10 min)
To Next Page
Loading...
