14
(5)
Cleaning and replacing the pinch roller.
Clean the pinch roller (product number: SPA-0166 or SPA-0167) when it is dirty.
Also, when the pinch roller wears out or the dirt of the pinch roller does not fall, replace the pinch roller.
1
Raise the clamp lever.
2
Remove the O-ring retaining the pinch roller.
3
Pull out the Pinch Roller shaft with care not to
drop the pinch roller.
4
Remove the pinch roller.
5
Clean or replace the O-ring and pinch roller.
• Wipe off the ink sticking to the O-ring and pinch roller with a
clean stick dipped in cleaning solution for maintenance. Wipe
off so that cleaning solution for maintenance will not remain.
• If it does not become clean even after cleaning, replace the
pinch roller with the following procedure.
(1) Install a new pinch roller.
(2) Insert the PR axis and fit O ring.
• Be careful not to drop the parts in the gap of
the machine as they are small.
To Next Page
Loading...
