MIMAKI CJV300-160 - Adjusting Blade Edge of Cutter Other than Supplied One

5-19
5
2
Adjusting blade edge of cutter other
than supplied one
1
Loosen the lock nut.
2
Turn the adjusting knob to adjust the
protruding amount of the cutter blade.
3
Tighten the lock nut so that the adjusting
knob will not turn.
• The blade adjuster (Product No.: OPT-S1005) will
facilitate the adjustment of the protruding amount
of the blade.
Lock nut
Adjusting
knob