3-6
Chapter 3 Setup
Setting of Drying Time
In the drying time setting, the following items for ink drying
time are set.
• SCAN : Ink drying time for each scanning is set. (During
bidirectional printing, the machine stops for a
certain period of time specified for each of the
outward and return scanning.)
1
Press the
(MENU)
key in
LOCAL.
• SETUP MENU will be displayed.
2
Press times, and then press the
key.
• “DRYING TIME” will be selected.
3
Press the key.
4
Press to set drying
time, and then press the key.
• Set the drying time for canning and after printing
is completed. To enable the drying time specified
in your RIP, select “Host”.
• Setting value :
Host or 0.0 sec. to 9.9 sec.
• Item selecting : by the [][] keys
• Time setting : by the [][] keys
5
Press the key several times
to end the setting.
Setting of Left and Right Margins
Set a non-printing area along the left and right edges of
the media.
The offset value against the standard margin 15mm is set
hereupon.
1
Press the
(MENU)
key in
LOCAL.
• SETUP MENU will be displayed.
2
Press the
(PAGE>)
.
3
Press the times to select “Margin/L”
or “Margin/R”, and then press the
key.
4
Press to select a set value, and
then press the key.
• Set value : HOST / -10 to 85 mm
5
Press the key several times
to end the setting.
Setting of VacuumFan
Sets the absorbability of the media.
By setting the absorption power to match the media, you
can prevent print errors due to media rise-up.
1
Press the
(MENU)
key in
LOCAL.
• SETUP MENU will be displayed.
2
Press the
(PAGE>)
, and then press
.
• “VACUUM FAN” will be selected.
3
Press the key.
4
Press to select a set value, and
then press the key.
• Set value : HOST/WEAK /STANDARD/ STRONG
5
Press the key several times
to end the setting.
• When you give priority to the setting at the
RasterLink side, make the setting value “Host”.
• “SCAN” set in this machine is displayed as
“Pause Time per Scan” in the RasterLink.
• You cannot specify the print end at the RasterLink
side. When you set this machine to “Host”,
printing will be performed in “PRINT END= 0 sec.”
status.
• When you give priority to the setting at the RIP
software side, make the setting value “Host”.
• You cannot specify the margins at the attached
RIP software (RasterLink). When you use the
RasterLink, if you set this machine to “Host”,
printing will be performed in “Margins for right and
left off set value= 0 mm” status.
• The margin setting is reflected when the media
width is detected.
• Pay attention to that printing may start on the
media press if a right and left margin is set to 5
mm or less when the media press is used in
printing.
To Next Page
Loading...
