2-7
2
2
2
2
2
Media Size and the Grit Roller (CJV300-130)
The grit roller positions are determined by the size of the media.
• To feed the media smoothly, select the grid roller positions so that the media can be held at equallyspaced intervals.
• When the grid rollers to be used are determined, adjust the pinch roller unit referring to "How to Adjustthe Pinch Roller" of
P. 2-17.
• You can use any number of pinch roller units from 2 to 6.
• Adjust the pinch roller of both ends so that they are within the range of 10cm from media left end and 2cm from media
right end. If adjusting them to the further position, it will remain uncut when cuttingthe media.
1328 ~ 1371mm1328 ~ 1371mm
1212 ~ 1272mm1212 ~ 1272mm
1032 ~ 1092mm1032 ~ 1092mm
732 ~ 792mm732 ~ 792mm
576 ~ 644mm576 ~ 644mm
362 ~ 422mm362 ~ 422mm
241 ~ 301mm241 ~ 301mm
1252 ~ 1312mm1252 ~ 1312mm
1136 ~ 1196mm1136 ~ 1196mm
956 ~ 1016mm956 ~ 1016mm
656 ~ 716mm656 ~ 716mm
500 ~ 568mm500 ~ 568mm
286 ~ 346mm286 ~ 346mm
165 ~ 225mm165 ~ 225mm
1164 ~ 1224mm1164 ~ 1224mm
1048 ~ 1108mm1048 ~ 1108mm
868 ~ 928mm868 ~ 928mm
568 ~ 628mm568 ~ 628mm
414 ~ 480mm414 ~ 480mm
198 ~ 258mm198 ~ 258mm
85 ~ 137mm85 ~ 137mm
GR1GR1
GR2GR2GR4GR4
GR3GR3
GR10GR10 GR5GR5GR6GR6GR7GR7GR8GR8GR9GR9
Determine the grid rollers to be used
according to the size of the media.
The right end of the media
should come within this range.
GR : Grit roller
To Next Page
Loading...
