MIMAKI JV33-260 Supplement For The Basic Operation Manual

Thank you very much for your purchase of the JV33-260.
From the firmware Ver. 5.60, the function below were added. Please read this manual and fully understand it before
using the device.
If you have any question, contact your local distributor.
In case that feeding stripes cannot be resolved even though media correction is performed, make “MAPS (Mimaki
Advanced Pass System) valid. Feeding stripes become less visible by distributing the pass boundary.
1
Press the key in LOCAL.
2
Press the key.
3
Press the key.
4
Press to select [MAPS].
Perform setting to reduce stripes between passes
• MAPS effect differs depending on the set value of the printing speed. Use it after checking effect
in advance.
• When you speed up the printing speed, it takes shorter time to print. However, MAPS effect
becomes weak.
• When you slow down the printing speed, it takes longer time to print. However, MAPS effect
becomes strong and feeding stripes become less visible.
• The resolutions and passes for which MAPS is enabled are shown in the following table.
• For conditions when MAPS is disabled, the printer operates with MAPS-OFF and print speed
settings disabled (±0%).
• MAPS may not be effective depending on image to be printed.
• Slight color change may be found.
Resolution
(dpi)
Pass
4 colors 6/ 7/ 8 colors
△○◎△○◎
540x720 2 4 8, 16 816, 32
540x1080
6 12, 24 12 24, 48
720x720 4 8, 16 816, 32
720x1080
6 12, 24 12 24, 48
720x1440
8 16, 32 16 32, 64
◎ : MAPS can be used when the print speed setting is within a range of ±50%, for both high speed and
standard speed.
○ : At high speed, print speed is within the range of -50% to -1%. At standard speed, MAPS can be
used when the print speed is within a range of ±50%.
△ : MAPS can be used when the print speed setting is within the range of -50% to -1% at standard
speed only.
FUNCT I ON
SETUP <ENT>
SETUP
SELECT : TYPE . 1
[1]
MED I A COMP . < e n t >
[1]
MAPS < e n t >
5
Press the key.
6
Press to set ON/OFF.
• Set Value : OFF, ON
7
Press the key.
• When you select OFF, proceed to the Step 9.
8
Press to change print speed.
• Set Value : -50 ~ +50%
(If +20% is entered, the print speed increases by
approximately 20%. If -20% is entered, the print speed
decreases by approximately 20%.)
9
Press the key.
10
Press the key several times to end the setting.
[1]MAPS
SETUP : OFF
[1]MAPS
SETUP : ON
[1]MAPS
PR I NT SPEED : 0%
[1]MAPS
PR I NT SPEED : 1 0%
[1]
MAP S < e n t >

MIMAKI JV33-260 Specifications

General

Brand	MIMAKI
Model	JV33-260
Category	Printer
Language	English