MIMAKI TS300P-1800 - Powering On and Off; Image Quality and Nozzle Issues; Ink Specifications

- 3 -
Prepare TS300P-1800
Following the procedures below, prepare TS300P-1800.
1.
Connect a PC in which the RasterLink is
installed with TS300P-1800.
• For details, refer to Chapter 1 “Connecting Cables”
of TS300P-1800 Operation Manual.
2.
Turn on the power supply of TS300P-1800.
• For details, refer to Chapter 2 “Turning the Power ON”
of TS300P-1800 Operation Manual.
3.
Before setting a media, check the height of
print head.
• For details, refer to Chapter 2 “Adjusting the Head
Height” of TS300P-1800 Operation Manual.
• Adjust the Height-adjusting lever depending on the media
to be used.
4.
Set the media.
• When setting the roll media : Chapter 2 “Setting a roll media” of TS300P-1800 Operation
Manual
• When setting the leaf media : Chapter 2 “Setting leaf media” of TS300P-1800 Operation
Manual
5.
Perform a test printing.
• Check if discharging defect such as nozzle clogging exists or not.
• For details, refer to Chapter 2 “Test Printing” of TS300P-1800 Operation Manual.
6.
Perform a media correction.
• Correct the feeding rate of media.
• For details, refer to Chapter 2 “Setting of Media Correction” of TS300P-1800 Operation Man-
ual.
7.
Perform a dot position correction.
• Correct the ink drop position.
• For details, refer to Chapter 2 “If the Positions of Dots Shift...” of TS300P-1800 Operation
Manual.
USB cable
or
Ethernet cable
Power switch
Height-adjusting lever