MIMAKI TS300P-1800 - Machine Parts and Functions; Media Setup and Adjustment; Optimal Print Conditions Setup; Warning and Error Messages

- 4 -
Prepare the Mimaki Driver
1.
Check if the attached Mimaki Driver is installed.
• For the installation, refer to Installation Guide of the attached Mimaki Driver.
Prepare the TxLink3
Check that the software RIP [TxLink3] is prepared.
1.
Check if the TxLink3 is installed.
• TxLink3 is displayed on the Start menu if the software is
already installed.
• For the installation, refer to Installation Guide of the RasterLink.
2.
Check the connection with TS300P-1800.
(1) Is the power supply of TS300P-1800 turned ON?
(2) Is the PC in which the TxLink3 is installed connected with TS300P-1800?
3.
Place the installation CD for TxLink3 in the disk drive.
• Exit the autorun of the CD if it occurs.
4.
Start TxLink3.
• Select TxLink3 from the Start menu.
5.
Import the print environment file.
• The print environment file contains the initial values of model, profile, and output settings. You can
perform appropriate outputs by using this file.
• If the print environment file is already set up, the following operation steps are not required. Then
proceed to 6.
(1) Select [Import] in the [No print environment has
yet been defined] screen.
(2) Open the [Print environments] folder in the installation CD for TxLink3.
(3) Select the profiles for desired media/output settings, and click [Open].
(4) The [Print Environments] screen is displayed.
• You can select multiple files simultaneously.