6
WARNING
Wearing protective devices
• When cleaning the suction nozzle, which may scatter ink, be sure to wear safety glasses and gloves,
or ink and cleaning solution might enter your eyes or ink and cleaning solution put on your hands
might make your hands rough.
Power supply and voltage
• Use this machine with indicated power specifications.
Be sure to connect the power cable plug to the grounded outlet, or it may cause fire or electric shock.
• Never look at the LED UV being lit with your naked eyes, or it may cause pain in your eyes or visual
impairment. Be sure to wear safety glasses.
• Do not apply ultraviolet (UV) light directly to your skin, or it may cause irritation on your skin.
• To prevent electrical shock, be sure to set OFF the main power circuit breaker and disconnect the
power plug before carrying out maintenance. For some units, capacitors may take one minute for dis-
charging; therefore, start maintenance work three minutes after setting OFF the main power circuit
breaker and disconnecting the power plug.
• If LED UV has been damaged, you should replace the LED UV that has reached or has past its rat-
ing life.
• The main power circuit breaker should be set ON only by personnel with sufficient knowledge about
operations of this machine.
• Do not touch the lamp with bare hands while lighting or right after the lamp off to avoid from burn
injury.
Handling of the antifreeze liquid
• Use the exclusive antifreeze liquid, or the cooling device may be damaged.
• If the antifreeze liquid or mixed soft water with antifreeze liquid gets on the skin or clothes, immedi-
ately wash it off with soap.
If you get the antifreeze liquid in your eyes, immediately wash your eyes with a lot of clean water.
Then, consult a doctor as soon as possible.
• Before using the antifreeze liquid, be sure to read the Material Safety Data Sheet (MSDS).
• If you swallowed the antifreeze liquid accidentally, try to get to vomit, and then consult a doctor as
soon as possible.
• Discard the waste antifreeze liquid or used mixed soft water with antifreeze liquid as follows;
Absorb in a sawdust or waste cloth, then incinerate it.
• Entrust to an industrial waste disposal contractor, clarifying their contents.
• Avoid causing ignition with static electricity, impact spark and so on.
• Be sure to wear goggles and gloves for handling the antifreeze liquid.
Handling of the power cable
• Use a power cable attached to this machine.
• Take care not to damage, break or work on the power cable. If a heavy things are put on the power
cable, heated or drawn, the power cable can break to cause fire or electric shocks.
Handling of LED UV
• Do not use the LED UV in an ambience with a possibility of catching fire (gasoline, combustible gas
spray, thinner, lacquer, powder dust, etc.). In addition, do not put paper or cloth near or on the LED
UV, or it may cause fire, or it may cause electrical shock.
To Next Page
Loading...
Need help?
General