MIMAKI UJF-A3MkII Series User Manual

For safe operation
8
Cautions on Installation
Cleaning
• After using this machine long time, foreign materials
and dust may be gathered on the conductive and
insulating parts, causing electric leakage. Periodically
clean such parts.
• For cleaning, do not use compressed air because it
scatters foreign materials and dust, which may cause
malfunctions when put inside the conductive parts. Be
sure to use vacuum cleaner to vacuum off foreign
materials and dust.
• Do not use the machine in a place where there is a
possibility of being wet, or electricity may leak.
• Electrical leakage may lead to electrical shock of
personnel or fire.
• To prevent accidents, be sure to carry out periodic
inspections and replace periodic replacement parts.
Periodic exchange parts
• There are some parts which must be periodically
replaced. Contract with distributors or dealers for
maintenance.
Adjusting the level
• Keep this machine horizontal.
Firing and smoking
• Touching hot parts such as the LED UV with
combustible materials may cause firing and/or
smoking.
Leaving combustible materials under the LED UV unit
for a couple of minutes may also cause firing and/or
smoking.
• After this machine is used long time, foreign materials
or dust gathered may cause electrical leakage, or
insulation deterioration may cause firing and/or
smoking. Periodically clean this machine and replace
the deteriorated parts after the insulation resistance.
• After this machine is used long time, screws or others
on the conductive parts may be loosened, causing
firing and/or smoking. Periodically tighten the screws.
• If abnormalities such as a strange odor, a smoking or a
spark burn occurred, turn the power off and call our
office immediately.
CAUTION
CAUTION
A place exposed to direct
sunlight
On an inclined surface
A place that vibrates
A place exposed to direct air
flow from an air conditioner
or the like.
A place where temperature or
humidity varies significantly
Around a place where fire
is used
•Use the machine
under the following
environmental
conditions:
• Operating environment:
20 to 30 °C
(68 to 86 °F)
35 to 65 % (Rh)

MIMAKI UJF-A3MkII Series Specifications

General

Brand	MIMAKI
Model	UJF-A3MkII Series
Category	Printer
Language	English