How to clear clogged nozzles on my MIMAKI UCJV150-160?
To clear clogged nozzles, you can try the following: * Perform head cleaning. * Perform print head nozzle washing. * Perform [MENU] > [Maintenance] > [INK FILL].
What to do if the ink has leaked from my MIMAKI Printer?
If an ink leak occurs, immediately turn off the main power and unplug the power cable. Then, contact your local dealer or our service office.
What to do if the light-blocking cover comes off my MIMAKI UCJV150-160?
If the light-blocking cover comes loose, reattach it by following these steps: 1. Insert the lug on one side of the light-blocking cover into the corresponding hole in the tank. 2. Insert the lug on the other side while pushing in toward the first hole.
Why does the media jam or get dirty in my MIMAKI UCJV150-160?
To address media jams or dirty media, consider the following: * Ensure you are using the recommended media. * Avoid using curled media or media with folded ends. * Use the take-up unit to adjust or reload the media.
How to fix image defects occurring on my MIMAKI UCJV150-160?
To address image defects, try the following: * Remove any paper scraps or debris from areas the head passes over, such as media holders. * Perform head cleaning. * Perform feed correction. * Clean the wiper. * Clean the cap rubber. * Clean the carriage underside.
How to correct misaligned print and cut positions on my MIMAKI UCJV150-160 Printer?
If the print and cut positions are misaligned, use the MIMAKI RIP software (RasterLink) to print a correction pattern. Then, check the pattern and manually input correction values.
Why does the cut position shift on my MIMAKI UCJV150-160?
If the cut position shifts, it may indicate a problem with the register mark sensor. Perform the operation used to check the responsiveness of the register mark sensor. Note that you cannot check the responsiveness manually.
How to troubleshoot a MIMAKI UCJV150-160 Printer when the power does not turn on?
To resolve the issue of the power not turning on, ensure the power plug is securely inserted into the power outlet, use the power cable provided, and turn on the main power.
What to do if the MIMAKI Printer power does not turn on?
If the MIMAKI Printer does not turn on, ensure the power plug is securely connected to the power outlet. Also, make sure you are using the power cable provided with the printer and that the main power is turned on.
How to fix image defects on MIMAKI UCJV150-160 Printer?
To fix image defects on your MIMAKI Printer, remove any paper scraps or debris from areas where the head passes, such as media holders. You may also need to perform head cleaning, feed correction, wiper cleaning, cap cleaning, and carriage underside cleaning. Additionally, consider performing an ink fill, replacing the wiper, or registering nozzle recovery.
Covers disclaimers, safety warnings, TV/radio interference, FCC regulations, and disposal.
Explains the meaning of various warning, caution, notice, and information symbols used in the manual.
Covers precautions for abnormal conditions, ink contact, power supply, moving parts, and disassembly.
Covers installation safety for environmental factors and location suitability.
Describes procedures for moving the machine and the function of safety interlocks.
Identifies and describes the various parts of the printer from different views.
Details connecting the power cable and PC, and turning the machine on/off.
Covers system configuration, RIP software setup, and ink replacement procedures.
Outlines essential precautions before performing any maintenance tasks.
Addresses issues like power, printing failures, and media jams with corrective actions.
To Next Page
General