MIMAKI UCJV300 - User Manual

UCJV300/150 ID Cut Guide
Congratulations on your purchase of an inkjet printer of MIMAKI (print & cut type).UCJV300/150 This " ID Cut
Guide", describes the method for ID cut by using UCJV300/150 and the supplied software. Precautions and pre-
defined settings are also described.
Note
• It is strictly prohibited to write or copy a part or whole of this document without our approval.
• This document has been carefully prepared for your easy understanding, however, please do not hesitate to
contact a distributor in your district or our office if you have any inquiry.
• Description contained in this document are subject to change without notice for improvement.
• Due to improvement or change of software, the description of this document could be partially different in
specification, for which your understanding is requested.
• With the exception of what is provided for in the warranty provisions of MIMAKI ENGINEERING CO., LTD., we
do not assume any liability against the damages (including but not limited to the loss of profit, indirect damage,
special damage or other monetary damages) arisen out of the use or failure to use of this product. The same
shall also apply to the case even if MIMAKI ENGINEERING CO., LTD. had been notified of the possibility of
arising damages in advance. As an example, we shall not be liable for any loss of the media made using this
product or indirect damages caused by the product made using this media.
• You can also download the latest operation manual from our website.
FineCut, RasterLink, RasterLink6Plus and CuttingLink are registered trademarks of MIMAKI ENGINEERING CO.,
LTD.
Adobe Illustrator is a trademark of Adobe Systems Incorporated.
CorelDRAW is a trademark of Corel Corporation.
Microsoft and Windows are registered trademarks of Microsoft Corporation of the U.S.A.
Apple and Macintosh are registered trademarks of Apple Inc. of the U.S.A. and each country.
All brand names and product names are trademarks or registered trademarks of their respective companies.

Summary

What is ID cut?

ID Cut Procedure

Preparation

Software; Driver List

Lists required software and drivers for ID cut, including RasterLink6Plus, CuttingLink, and Mimaki Driver.

Set up PC.

Guides users through connecting the PC to the printer and installing necessary software and drivers.

Printing, and ID Cutting

Set the media.

Explains how to set the media margins on the UCJV300/150 for correct print and cut alignment.

Print data.

Describes the process of loading sample files, adding register marks, and initiating printing with ID data.

ID cut

Explains how to detect the register mark and initiate the automatic cutting process after printing.

How to handle the following cases.

Troubleshooting

Provides solutions for common issues, such as disabled ID Cut or printing interruptions.

Changed CuttingLink - Server.

Instructions for re-registering CuttingLink with RasterLink6Plus after server changes.

Back up the data of CuttingLink - Server.

Details the folders that need to be backed up for CuttingLink server data.

Migrate CuttingLink - Server.

Steps for resetting initial settings and configuring the server for migration.

When to use CuttingLink - Client?

Explains the scenario for using CuttingLink - Client for multiple plotters beyond the server limit.

How to set CuttingLink - Client

Guides on installing and setting up CuttingLink on a client PC.

Data in the same place is cut twice

Addresses an issue where transparent effects cause double cutting and provides Adobe Illustrator settings to resolve it.

When you want to ID cut multiple types of data

Explains how to set consistent register mark shapes and sizes for multiple data types in ID Cut.

MIMAKI UCJV300 Specifications