- 8 -
Printing, and ID Cutting
The following shows you how to use and print out the sample images from the attached manual CD.
Set the media.
For detail, refer to the UCJV300/150 Operation Manual.
I you cut the media rotated by 90, 180, or 270 degrees, set the media margins to the following values at
rotated conditions.
• Front end: 110 mm or more
• Left and right ends: 15 mm or more
• Rear end: 110 mm or more
210 mm or more (When copying data with RasterLink6Plus.)
1. Set the media onto UCJV300/150.
2. Check if the print start position (the origin ) is set at 110 mm or more from the media
front end, and 15 mm or more from the media right end.
• Make sure that the width of the media is equal to or larger than [Entire image width (including the reg-
ister mark) + right 15 mm + left 15 mm].
• If any of the front / left / right margin is insufficient, the media end may be mistaken as the register
mark, which may cause the register mark detection to start earlier.
(1) Press the jog key in the local state. Move the luminous point of the LED pointer so that the print
start position is 110 mm or more from the media front end, and 15 mm or more from the right end.
(2) Press the [ENTER] key.
• The print start position is changed.
3. Check if the print end position is set at 110 mm or 210 mm (When copying data with
RasterLink6Plus.) from the media rear end.
• Make sure that the length of the media is equal to or larger than [Entire image length (including
the register mark) + 110 mm + 110 mm or 210 mm(When copying data with RasterLink6Plus.)].
• Make sure that you check P.5 "Preparation" and then print and cut.
To Next Page
Loading...
