- 5 -
Preparation
You need to prepare UCJV300/150 and the software/Driver before printing or ID cut.
If preparations have already been completed, go to"Printing, and ID Cutting" (P.8).
• Software / Driver List
The following software applications are required for ID cut. All software applications are provided by MIMAKI
ENGINEERING CO., LTD.
Set up PC.
1. Connect PC and UCJV300/150 with USB.
2. Install the software/driver.
(1) Install Mimaki Driver.
(2) Install RasterLink6Plus.
(3) Install CuttingLink.
3. Register UCJV300/150 with CuttingLink.
(1) Start CuttingLink from the start menu, or double-click
the CuttingLink icon created on the desktop to start
CuttingLink.
• The [Initial Setting] screen is displayed.
(2) On the [Initial Setting] screen, select [CuttingLink-Server],
and then click [OK].
• [Data Management] is displayed.
Software/Driver Description
RasterLink6Plus (Ver1.1 or later
*1
)
*1.When using a version earlier than the specified version, download the upgraded version of the installer
from the Mimaki website.(http://mimaki.com/
)
When using the "ID Cut Output" function of FineCut, use RasterLink6Plus Ver.1.2 or higher.
Software to receive image data, edit data with various functions, and
send plot data to the printer. (supplied with the printer: CD)
Refer to the attached RasterLink6Plus Installation Guide for the
installation method.
CuttingLink
Software to manage ID cut.
Download the installer from the Mimaki website(http://mimaki.com/
)
Refer to the attached "CuttingLink installation" of Raster-
Link6Plus Installation Guide for the installation method.
Mimaki Driver
Device driver for using an ink jet printer/cutting plotter from Mimaki
Engineering. (supplied with the printer: CD)
Refer to the attached Mimaki Driver Installation Guide for the
installation method.
To Next Page
Loading...
