This document bridges the gap between the Fiery XF documentation and the Mimaki UJV55-320 documentation.
Refer to the Installation section before you connect the printer to a computer.
The Operation section has information on profile generation and everyday use. Please refer also to the Operation
Manual.
For a UJV55-320 printer, select the Fiery XF driver that matches the ink configuration in the printer:
From the computer viewpoint, the Mimaki UJV55-320 is a special USB device with Ethernet support. The latest driver is
downloadable from http://www.mimaki.co.jp/
Follow the instructions in the Mimaki USB Driver Install Guide before you connect the printer. Mimaki USB Driver
version 4.0 or later is recommended. Furthermore, the Mimaki network driver is supported from version 1.2 onwards.
1 Install Fiery XF and the latest Fiery XF service pack that supports the Mimaki UJV55-320 printer. The minimum
requirement is Fiery XF 7.1.
2 To configure the Fiery XF printer:
• In System Manager, add the printer by clicking on the plus (+) icon and selecting “Mimaki”as the manufacturer
and “Mimaki UJV55-320 CMYKcmW” as the printer type.
• In the Connection panel. select the Connection type “Print via port” or “Print via IP network”.
To Next Page
Need help?
General