i
Safety Warnings
Note: This symbol denotes an important safety message.
Please read these sections very carefully before performing any
calibration, repair, or other procedure contained in this manual.
• Have a qualified electrical maintenance technician install, adjust,
and service this equipment. Follow the National Electrical Code
and all other applicable electrical and safety codes, including the
provisions of the Occupational Safety and Health Act (OSHA),
when installing equipment.
• Reduce the chance of an electrical fire, shock, or explosion by
proper grounding, over current protection, thermal protection,
and enclosure. Follow sound maintenance procedures.
It is possible for a drive to run at full speed as a result
of a component failure. Minarik strongly recommends the
installation of a master switch in the main power input to
stop the drive in an emergency.
Circuit potentials are at 115 VAC or 230 VAC above earth
ground. Avoid direct contact with the printed circuit board or
with circuit elements to prevent the risk of serious injury or
fatality. Use a non-metallic screwdriver for adjusting the cal-
ibration trimpots. Use approved personal protective equip-
ment and insulated tools if working on this drive with power
applied.
To Next Page
Loading...
Need help?
General
