Table of Contents
4
6-45
6.8.3 Replacing the sample transport unit....................................................... 6-46
6.9 Mix mechanism.................................................................................................... 6-58
6.10 Adjustment........................................................................................................... 6-66
6.10.1 Adjusting Sample Probe Position........................................................... 6-66
6.10.2 Adjusting Pincher Position ..................................................................... 6-73
7 Optical System..................................................................................................... 7-1
7.1 Optical System Adjustment and Troubleshooting.................................................. 7-1
7.2 Removing and Installing Optical System Assemblies............................................ 7-3
7.2.1 Laser driver board .................................................................................... 7-3
7.2.2 Front light assembly ................................................................................. 7-4
7.2.3 Flow cell assembly ................................................................................... 7-5
7.2.4 Rear light collimator assembly ................................................................. 7-7
7.2.5 Beam splitter assembly ............................................................................ 7-7
7.2.6 Rear light collector assembly ................................................................... 7-8
7.2.7 Rear light detector assembly.................................................................. 7-10
7.3 Adjustment........................................................................................................... 7-12
7.3.1 Coarse adjustment ................................................................................. 7-12
7.3.2 Preparation before fine tuning................................................................ 7-18
7.3.3 Fine tuning.............................................................................................. 7-19
7.3.4 Gain setup .............................................................................................. 7-24
7.4 Troubleshooting ................................................................................................... 7-27
7.4.1 Laser spot-deviation............................................................................... 7-27
7.4.2 Flow cell clog.......................................................................................... 7-27
7.4.3 Dirty flow cell .......................................................................................... 7-28
8 Troubleshooting .................................................................................................. 8-1
8.1 Error code and information.................................................................................... 8-1
8.2 Errors indicated by error messages ...................................................................... 8-9
8.2.1 Pressure errors......................................................................................... 8-9
8.2.2 Reagent errors ......................................................................................... 8-9
8.2.3 Hardware errors ..................................................................................... 8-10
8.2.4 Measurement errors............................................................................... 8-10
8.2.5 Temperature errors................................................................................. 8-12
8.2.6 Scattergram errors ................................................................................. 8-13
9 Appendixes ......................................................................................................... A-1
A. Accessories ...........................................................................................................A-1
B. List of Wearing Parts .............................................................................................B-1
C. Fluidic diagram ..................................................................................................... C-1
D. Pump and Valve Function Table ........................................................................... D-1
E. Tubing ....................................................................................................................E-1
F. Method to identify cross network cable and direct-connected network cable ....... F-1
To Next Page
Loading...
