Minebea Intec S-Type Load Cell LC Tigo PR 76 - Ordering Information; Technical Data

4.5 Ordering information
Model Max. capacity
E
max
Type
PR 76/60 kg 60 kg ..N/C3
PR 76/125 kg 125 kg ..N/C3
PR 76/250 kg 250 kg ..N/C3
PR 76/500 kg 500 kg ..N/C3
PR 76/1 t 1 t ..N/C3
PR 76/2 t 2 t ..N/C3
PR 76/3 t 3 t ..N/C3
PR 76/5 t 5 t ..N/C3
4.6 Technical data
Designation Description Abbr. N C3 Unit
Accuracy class 0.03 0.020 % E
max
Minimum dead load lowest limit of specified measu-
ring range
E
min
0 0 % E
max
Maximum capacity highest limit of specified mea-
suring range
E
max
See Chapter
4.5
Safe load limit maximum load without irrever-
sible damage
E
lim
150 % E
max
Destructive load danger of mechanical destructi-
on
E
d
300 % E
max
Minimum LC verification minimum load cell scale inter-
val, v
min
= E
max
/Y
Y … 8333
Minimum preload signal
recurrence
recurrence of the minimum pre-
load signal (DR = ½×E
max
/Z)
Z … 3000
Rated output relative output at maximum ca-
pacity
C
n
2 mV/V
Tolerance on rated out-
put
permissible deviation from ra-
ted output C
n
d
c
<0.25 % C
n
Zero output signal load cell output signal under un-
loaded condition
S
min
0 ±2.0 % C
n
Repeatability max. change in load cell output
for repeated loading
ɛ
R
<0.012 <0.012 % C
n
Creep max. change of output signal at
E
max
during 30 minutes
d
cr
<0.030 <0.017 % C
n
Non-linearity
1)
deviation from best straight line
through zero
d
Lin
<0.030 <0.017 % C
n
S-Type Load Cell LC Tigo PR 76 4 Specifications
EN-10 Minebea Intec