Minebea Intec S-Type Load Cell LC Tigo PR 76 - Selecting Maximum Capacity

3.2 Selecting maximum capacity
If there is a risk of the safe load limit E
lim
being exceeded (even only temporarily, e.g. by
falling loads), mechanical limiting in load direction is required.
- Loads exceeding the safe load limit E
lim
of the load cell may change its characteristics
or damage the load cell.
- Loads exceeding the destructive load E
d
of the load cell can led to its mechanical
destruction.
3 Recommendations for installation S-Type Load Cell LC Tigo PR 76
Minebea Intec EN-7