101
11. Stored place of setting data
In this unit, each data is recorded in RAM and EEPROM as follows:
The data in EEPROM can be stored almost permanent due to nonvolatile.
Moreover, RAM is backed up with the battery. (The backup time is about ten years in the room
temperature.)
11-1. Data recorded in RAM
● Tare weight cancellation data ● Preset tare weight cancellation data
● Zero tracking data ● Accumulated value, Accumulated count data
● Zero set data
11-2. Data recorded in EEPROM
● Calibration data ● SQ function data
● Function data ● Digital linearize data
● C function data
11-3. Data can be changed saving location
The saving location of follow data’s, is selected by C function CF-17
The saving location is selected from [RAM] or [EEPROM].
The item to which the saving location can be changed is as follows.
[RAM] is set as a default.
● Measurement comparison value 1 setting data
● Measurement comparison value 2 setting data
・ Please set the stored place to the internal RAM when the set value is continuously changed, and the
rewritable time of EEPROM might exceed about one million times.
・ Please do not change in the set value under the measurement because the A/D sampling rate
decreases temporarily while rewriting the set value. Please set the storing place to the internal ROM
when you change the set value during the measurement.
To Next Page
Loading...
