VI
4. Conformity standard
This instrument has suited the following standard.
EN61326：2006
[Electrical equipment for measurement, control, and laboratory use － EMC requirements]
[Immunity test requirements for equipment intended for use in industrial locations]
EN61010-1：2001
[Safety requirements for electrical equipment for measurement, control and laboratory use
- Part 1：General requirement]
Annex C (Performance level H) of JIS B 7611-2：2009
[Non-automatic weighing instruments – Metrological and technical requirements and tests
- Part 2：Measuring instruments used in transaction or certification]
Caution
The instrument with the software ver.2.100 or later conforms to the JIS standard.
Caution
Please observe the following conditions strictly when this instrument suits the below if neglected, it
may not conform to the above standard.
(1) Shield processing
- Use the shielded cable other than the power cable.
- Refer to relative notes, for method of shielding process.
(2) Grounding
- The ground of this instrument shall apply the individual ground by using the protective ground
terminal.
To Next Page
Loading...
