26
5. F3S Configuration Yellow Endcap.
5.1 Introduction.
The F3S permits the volume, sensitivity and ground balance
parameters of a detector to be customised.
5.2 Description.
To customise the performace of the F3S detector a Yellow
Sensitivity Endcap is fitted and the detector is connected to a
computer via the Earset Socket with a proprietary Minelab
programming cable. Using the Minelab „Configuration Editor‟
software the sensitivity, audio volume and ground balance can be
checked, reset to default or edited.
When a Yellow Sensitivity Endcap is connected to an F3S the
detector will switch to the settings last uploaded from the
configuration editor. If the F3S has not been previously programmed
the detector will default to the same settings as the Black Sensitivity
Endcap.
Details on how to use the configuration editor are provided in the
Help File contained in the software.
**WARNING**
When using an F3S with Yellow Sensitivity Endcap and
customised sensitivity, audio volume or ground balance it is
the responsibility of the user to provide a suitable test piece
to confirm the performance of the F3S.
To Next Page
Loading...
Need help?
General
