Minelab F3 Mine Detector - 6.2 Standard Operation Procedure

28
6.2 Standard Procedure.
After unpacking the F3 and preparing it for use as described in
Chapter 2 (appropriate Sensitivity Endcap fitted as directed by the
local authority), complete the THREE step standard procedure as
follows:
Figure 16: F3 Controls
a. STEP 1 Switch ON
 Hold the coil at least 600mm (24ins) from the ground and away
from any metallic objects. Turn the detector on by sliding the
On/Off switch back towards the handle.
Figure 17: Switching on the Detector