Minelab GPX 4800 User Manual

45
To restore Factory Preset settings for the
current Search Mode:
GPX 5000 Note: If you wish to reset a Custom Search Mode
ensure it is selected in the menu before shutting down
the detector.
1 Turn the detector off.
2 On the Front Control Panel, set the Search Mode switch to
the mode you wish to restore to Factory Presets.
3 Press the On/ Off switch down and hold until the Reset
Defaults menu appears (approximately 5–6 seconds).
4 Turn Function Select to the right to select the Search Mode.
Note: If the displayed Search Mode is not the one you wish
to restore you must change the Search Mode on the Front
Control Panel switch.
5 Turn Setting left or right to restore Factory Preset settings for
the mode selected.
The detector will restore Factory Presets and re-start.

Minelab GPX 4800 Specifications

General

Brand	Minelab
Model	GPX 4800
Category	Metal Detector
Language	English