Minelab VANQUISH 440 User Manual

9
CONTENTS
Beep!
Beep!
Pinpoint
LOCATE A TARGET MANUALLY
It is possible to locate a target successfully without using
Pinpoint, however this requires practice� This method may be
required when a desirable target is surrounded by trash�
1� Sweep the coil slowly across the target location keeping
the coil parallel to the ground�
2� Locate the centre of the target by listening for the loudest
target signal response�
3� Make a mental note of the position, or mark a line on the
soil with your shoe or a digging tool�
4� Move to one side so that you can pass the coil over the
target at right angles to your initial direction�
5� Repeat steps 1 and 3 from your new position� The target is
located where the two imaginary lines cross�
Beep!
Beep!
Make a line where the
strongest signal is heard�
Stand at right‑angles to
your initial position and
repeat�
The intersection of the
two lines marks the exact
location of the target�
1‑3
4‑5

Minelab VANQUISH 440 Specifications

General

Technology	Multi-IQ
Discrimination Segments	12
Audio Tones	3
Iron Bias	High
Sensitivity	10 levels
Volume	10 levels
Display	LCD
Backlight	No
Pinpoint Mode	Yes
Coil Type	Double-D
Search Modes	Coin, Jewelry
Battery	4 x AA
Water Resistance	Coil waterproof to 1 m (3.3 ft)
Audio Output	Built-in speaker and 3.5mm (1/8") headphone jack
Coil Size	10" x 7"
Searchcoil	10x7” DD
Length	Adjustable (1.1m - 1.3m)